NETGEAR GS724Tv3 - ProSafe Gigabit Managed Switch

GS716Tv2 and GS724Tv3 Software Administration Manual
Configuring Switching Information 3-43
v1.0, July 2009
IGMP Snooping Querier Configuration
Use this page to enable or disable the IGMP Snooping Querier feature, specify the IP address of
the router to perform the querying, and configure the related parameters.
To access this page:
1. Click Switching Multicast  IGMP Snooping Querier  IGMP Snooping  Querier
Configuration in the navigation tree.
2. Click Refresh to redisplay the page with the latest information from the switch.
Figure 3-27
Table 3-25. IGMP Snooping Querier Configuration Fields
Field Description
Querier Admin Mode Select the administrative mode for IGMP Snooping for the switch from
the menu. The default is Disable.
Snooping Querier Address Specify the Snooping Querier Address to be used as source address in
periodic IGMP queries. This address is used when no address is
configured on the VLAN on which the query is being sent.
IGMP Version Specify the IGMP protocol version used in periodic IGMP queries.
Query Interval Specify the time interval in seconds between periodic queries sent by
the snooping querier. The Query Interval must be a value in the range of
1–18000 seconds. The default value is 60.
Querier Expiry Interval Specify the time interval in seconds after which the last querier
information is removed. The Querier Expiry Interval must be a value in
the range of 60–300 seconds. The default value is 60.