NETGEAR GS724Tv3 - ProSafe Gigabit Managed Switch

GS716Tv2 and GS724Tv3 Software Administration Manual
Configuring Switching Information 3-23
v1.0, July 2009
2. Click Refresh to update the information on the screen with the most current data.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
4. If you make any configuration changes, click Apply to send the updated configuration to the
switch. Configuration changes take place immediately.
CST Port Status
Use the Spanning Tree CST Port Status page to display Common Spanning Tree (CST) and
Internal Spanning Tree on a specific port on the switch.
To display the Spanning Tree CST Port Status page:
1. Click SwitchingSTPAdvanced  CST Port Status in the navigation tree.
Port ID The port identifier for the specified port within the CST. It is made up
from the port priority and the interface number of the port.
Hello Timer Specifies the switch Hello time, which indicates the amount of time in
seconds a port waits between configuration messages. The value is
fixed at 2 seconds.
Figure 3-14
Table 3-13. Spanning Tree CST Port Configuration/Status Fields (continued)
Field Description