GS716Tv2 and GS724Tv3 Software Administration Manual
2-20 Configuring System Information
v1.0, July 2009
Trap Flags
The pages in the Trap Manager folder allow you to view and configure information about SNMP
traps the system generates.
Use the Trap Flags page to enable or disable traps the switch can sent to an SNMP manager. When
the condition identified by an active trap is encountered by the switch, a trap message is sent to any
enabled SNMP Trap Receivers, and a message is written to the trap log.
To access the Trap Flags page:
1. Click System SNMP SNMP V1/V2 Trap Flags.
Community String Enter the community string for the SNMP trap packet to be sent to the trap
manager. This may be up to 16 characters and is case sensitive.
Status Select the receiver’s status from the pulldown menu:
• Enable - Send traps to the receiver.
• Disable - Do not send traps to the receiver.
Table 2-12. Command Buttons
Field Description
Add Add the currently selected receiver configuration to the switch.
Delete Delete the currently selected receiver configuration.
Cancel Cancel the configuration on the screen. Reset the data on the screen to the
latest value of the switch.
Apply Sends the updated configuration to the switch. Configuration changes take
effect immediately.
Table 2-11. SNMP Trap Configuration (continued)
Field Description
To Next Page
Loading...
