NETGEAR GS724Tv3 - ProSafe Gigabit Managed Switch

GS716Tv2 and GS724Tv3 Software Administration Manual
3-8 Configuring Switching Information
v1.0, July 2009
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
3. If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.
LACP Configuration
To display the LACP Configuration page:
1. Click Switching LAG  Advanced  LACP Configuration in the navigation tree.
2. Click Refresh to reload the page and display the most current information.
Port Selection Table Select the ports as members of this LAG.
Current Members Displays the LAGs on the current channel.
Figure 3-5
Table 3-5. LACP Configuration Fields
Field Description
LACP System Priority Specifies the device’s link aggregation priority relative to the devices at
the other ends of the links on which link aggregation is enabled. A
higher value indicates a lower priority. You can change the value of the
parameter globally by specifying a priority from 0–65535. The default
value is 32768.
Table 3-4. LAG Membership Fields (continued)
Field Description