GS716Tv2 and GS724Tv3 Software Administration Manual
Configuring System Information 2-19
v1.0, July 2009
Trap Configuration
This page displays an entry for every active Trap Receiver. To access this page, click System
SNMP SNMP V1/V2 Trap Configuration in the navigation tree.
Table 2-10. Command Buttons
Field Description
Add Add the currently selected receiver configuration to the switch.
Delete Delete the currently selected receiver configuration.
Cancel Cancel the configuration on the screen. Reset the data on the screen to the
latest value of the switch.
Apply Sends the updated configuration to the switch. Configuration changes take
effect immediately.
Figure 2-10
Table 2-11. SNMP Trap Configuration
Field Description
Recipients IP Enter the address in x.x.x.x format to receive SNMP traps from this device.
Version Select the trap version to be used by the receiver from the pulldown menu.
• SNMP v1 - Uses SNMP v1 to send traps to the receiver.
• SNMP v2 - Uses SNMP v2 to send traps to the receiver.
To Next Page
Loading...
