NETGEAR GS724Tv3 - ProSafe Gigabit Managed Switch - Page 221

GS716Tv2 and GS724Tv3 Software Administration Manual
Maintenance 7-15
v1.0, July 2009
2. Click Cancel to cancel the operation on the screen and reset the data on the screen to the latest
value of the switch.
3. Click Apply to initiate the traceroute. The results display in the TraceRoute box.
Figure 7-9
Table 7-7. TraceRoute Fields
Field Definition
IP Address Specify the IP address.
Probes Per Hop Enter the number of times each hop should be probed. The valid range is 1–10.
MaxTTL Enter the maximum time-to-live for a packet in number of hops. The valid range is
1–255.
InitTTL Enter the initial time-to-live for a packet in number of hops. The valid range is 0–
255.
MaxFail Enter the maximum number of failures allowed in the session. The valid range is
0–255.
Interval Enter the time between probes in seconds. The valid range is 1–60.
Port Enter the UDP destination port in probe packets. The valid range is 1–65535.
Size Enter the size of probe packets. The valid range is 0–65507.
TraceRoute Displays the output from a traceroute.