Table 1. LED descriptions (Continued)
DescriptionLED and Button
Pressing the Sync/WPS button lets your WPS-enabled device join your router’s
WiFi network without typing the WiFi password.
Solid white: The Sync/WPS LED is always solid white. This is normal behavior.
Blinking white: The WPS process is active so that you can connect a WPS-enabled
device to your router’s WiFi network. When the device is connected, the sync/WPS
LED shows solid white again.
The Sync/WPS LED is also blinking white when the router is in factory default state
or you reset the router to factory default settings.
Off: All WiFi radios are turned off and you cannot use WiFi to connect to the
router.
Sync/WPS LED9.
Pressing the LED On/Off button turns off all LEDs except for the Power LED.LED On/Off button10.
-
User Manual18Hardware Setup
Nighthawk WiFi 7 Tri-Band Router Model RS700
To Next Page
Loading...
