7.
If your Internet connection requires an account name or host name, do the following:
a.
In the Account Name section, click the Edit button.
b.
Enter the account name.
By default, the account name is the model number of the router.
c.
Click the Apply button.
d.
Select Internet.
The Internet Setup page displays again.
8.
If your Internet connection requires a domain name, type it in the Domain Name (If
Required) field.
For the other sections on this page, the default settings usually work, but you can
change them.
9.
Select an Internet IP Address radio button:
• Get Dynamically from ISP: Your ISP uses DHCP to assign your IP address. Your
ISP automatically assigns these addresses.
• Use Static IP Address: Enter the IP address, IP subnet mask, and the gateway IP
address that your ISP assigned. The gateway is the ISP router to which your router
connects.
10.
Select a Domain Name Server (DNS) Address radio button:
• Get Automatically from ISP: Your ISP uses DHCP to assign your DNS servers.
Your ISP automatically assigns this address.
• Use These DNS Servers: If you know that your ISP requires specific servers, select
this option. Enter the IP address of your ISP’s primary DNS server. If a secondary
DNS server address is available, enter it also.
11.
Select a Router MAC Address radio button:
• Use Default Address: Use the default MAC address.
• Use Computer MAC Address: The router captures and uses the MAC address
of the computer that you are now using. You must use the one computer that the
ISP allows.
• Use This MAC Address: Enter the MAC address that you want to use.
12.
Click the Apply button.
Your settings are saved.
13.
Click the Test button to test your Internet connection.
User Manual36Specify Your Internet Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700
To Next Page
Loading...
Need help?
General
