33
Global Solo Controls 1
All three solo modes can be switched between Latching or Momentary
modes from the console Services Screen –
MAST>SOLO: [LATCH]/[MOM]
Latch mode –
Affects SIP/AFL/PFL and is the 8424-default solo switch setting. This setting
allows for multiple console signals to be pressed and soloed at the same
time. Solos will remain on until the engineer deselects the solo switch on
each soloed channel or by pressing the RESET button in the global console
controls section of the 8424.
Momentary mode –
Selected from the services screen MAST>SOLO:[MOM].
Momentary mode affects SIP/AFL/PFL. In Momentary mode, when a solo is
pressed, it must be held to remain soloed, when the operator lets go of the
solo button, the solo is automatically cancelled.
To Next Page
Loading...
