Nice NDCC4001 - 9 Technical Characteristics of the Product

22
EN
9
TECHNICAL CHARACTERISTICS OF THE PRODUCT
WARNINGS: • All technical characteristics stated in this section refer to an ambient temperature of 20°C (± 5°C). • Nice S.p.A. reserves the right to apply
modications to products at any time when deemed necessary, maintaining the same intended use and functionality.
Model DIC4001 NDCC4002 NDCC4005 NDCC2301
Type Nice control unit for mono-phase or three-phases motors with mechanical or electronic limit switch
Power supply voltage Three-phase 3x400Vac / 3x230Vac (+10% -10%) 50/60Hz Mono-phase
1x 230Vac (+10% -10%) 50/60Hz
Motor max. power 1.1KW 2.2KW 5.5KW 1.5KW
Power in Stand-by mode <1W
Power board fuse F1, F2, F3: 6.3A type T quartz
F4: 1A type T quartz
F1, F2, F3: 10A type
T quartz
F4 1A type T quartz
F1: 10A type T quartz
F4: 1A type T quartz
NDA001 logic board fuse 3.15A type T
Output 1 (FLASH) for 1 LUCYB, MLB or MLBT ashing light signal (12V – 21W)
Output 2 (SCA) for signal indicator 24Vdc (max 10W)
Output 3 free contact (relay)
Trafc light output 24Vdc (max 10W)
BLUEBUS output 1 output with maximum load of 12 Bluebus units
Services output 24Vdc +/-15% between terminal Input 1 (S.S.) and Input STOP (see paragraph 3.5)
“STOP” input For normally closed, normally open, 8.2KΩ constant resistance or OSE optical type contacts; in self-learning
mode (a change from the memorised state prompts the "STOP" command)
“ALT” input For Normally Closed contacts of the safety circuit
Input 1 (STEP-STEP) For Normally Open contacts
Input 2 (OPEN) For Normally Open contacts
Input 3 (CLOSE) For Normally Open contacts
Radio connector SM connector for receiver types SMXI, SMXIS, OXI or OXIT
Radio AERIAL input 52 ohm for RG58 or similar type cable
Programmable functions 8 ON-OFF functions and 8 adjustable functions (see tables 5 and 7) and additional programming through the
Programming Unit and Oview Command
Functions in self-learning mode Self-learning of devices connected to the BlueBUS output. Self-learning of "STOP" type devices (contacts NO, NC
or 8.2KΩ resistance).
Self-learning of the motor version connected
Operating temperature -20°C ÷ +50°C
Use in particularly acid, saline or
potentially explosive atmospheres
No
Protection rating IP54
Vibration Assembly without oscillation (e.g. on a masonry wall)
Dimensions 310 x 210 x 125 mm
Weight 3.5 kg