- Ａ ･ -
Q0340グラフィック用ロゴ
060411デザイン部伊藤
VBA14001-R.3694.A
＜
Measurement of Consumption current value
＞
When this camera is used for measuring the consumption current value, connect the battery tool (J61213), and
turn the change-SW to OFF. Then make measurements based on the following.
＋
＋
－
－
7.8V 0.3Ω
Test item Standard Test condition
Main SW
・
OFF
All operational buttons are NOT pushed.
200 μ A or less
ref. above.
AF50/1.4D
、
EV12
Main SW
・
ON (Half-release timer OFF) 200 μ A or less
Main SW
・
ON (Half-release timer ON) 200 μ A or less
Main SW
・
ON (Illumination ON) 300 μ A or less
Main SW
・
ON (TFT ON)
1 A or less
《
Inspection standards
》
Turn change-SW to OFF.
Caution:
When the consumption current value is measured, backup battery must be fully charged.
Ａ
To Next Page
Loading...
