- Ａ ･ -
Q0340グラフィック用ロゴ
060411デザイン部伊藤
VBA14001-R.3694.A
#652
#185
Bayonet
1.7±0.15mm
Height adjustment of AF coupling shaft
①
Set the A/M change cam (#122) to
AF side. [i.e. The coupling shaft
(#
185) sticks out of the bayonet.
]
②
Adjust the height of the coupling shaft
(#185) with the screw (#652) so that
it becomes 1.7±0.15mm.
③
After the adjustment, x the screw
(#652) with screwlock.
#
122
A/M change cam
Adhesive: Screw lock
Height adjustment of Aperture lever
・
Measure the height of the aperture lever by using the tool (J18004).
Standard: 3.4±0.1mm
In case the value is out of standard, make an adjustment by bending the circled part.
Caution: Be careful NOT to bend the inner part of the lever when adjusting.
3.4±0.1mm
Aperture lever
To Next Page
Loading...
