- Ａ ･ -
Q0340グラフィック用ロゴ
060411デザイン部伊藤
VBA14001-R.3694.A
#1007
#629
#
#686×2
#280
#288
#282
#287
#281
#656
＊
When AE-CCD positioning adjustment is made,
assemble temporarily up to Page A38
without attaching the screws to the top cover, putting the diopter adjustment unit, and
soldering six wires.
Top cover
・
Connect the top cover-FPC (#1007) to the connector, and set the top cover.
・
Tighten the screws (#656, #629, and #624) and two screws (#686).
・
Put the diopter adjustment unit (#281, #287, #282, #288, and #280).
Diopter adjustment unit
＊
After setting the top cover, slide the diopter adjustment lever, and
check the movement of the diopter-correcting lens.
To Next Page
Loading...
