prw2101a0600p_01
43 / 105
5.4.4. List display
Max. 4 quantities can be selected.
2: SE360 62
PV
SV
TV
QV
Current
Percent
Level
Level%
TOT1
TOT2
Status
PV rate of change
Working
Head of fl.
Primary Value
Secondary Value
Tertiary Value
Quaternary Value
Current out of the transmitter*
PV in %
Level
Level in %
TOT1 and TOT2 Totalizer Values
during flow measurement
Status of the instrument
Change speed rate of Primary Value
Working hours of the instrument
Level (h) for calculate instantaneous
flow in case of flowmetering
180
2E6
3P8
:
x: ST340
: SE3
: S 3 0
: S 3 0
Source 61
Source
List display 60
:
* The output current, as a display quantity is recommended to use only, if there is only one device in the system, and if the „Short Address” is zero, i.e., if the current
output is not constant.
** The MultiCONT calculates the value of PV rate of change in every 5 sec. If there are more transmitters in the loop and this cycle time is more than 5 sec,
calculation of PV_Rate ( t1 - t2 5 sec) is performed per cycles.
Change speed rate of PV [PV/min]=( PV
t1-PV t2 )×60/(t1-t2)
To Next Page
Loading...