prw2101a0600p_01
97 / 105
No. Box Message Explanation
32 HART:Too large The received HART command is longer than standard
33 HART:Too small The received HART command is shorter than standard
34 HART:Few data
35 HART:Device spec. Bad parameter sent during remote programming
36 HART:Access restr.
37 HART:Busy
38 HART:Comm. not. imp. The received HART command is unknown to the MultiCONT
39 Please wait! DEV detect cannot run due to periodic disturbance on the HART line, which causes continuous error!
40 TOT cleared TOT deleted during relay progamming ( Impulse F )
41 TOT updated TOT updated during relay progamming ( Impulse F )
42 No in RP mode Device could not enter „Remote programming” (RP) mode during programming
43 Stick in RP mode Unsuccessful exit after remote programming of device
9.2. OTHER MESSAGES:
No. Message Explanation
1 Scanning HART line Displayed during device detection
2 Logical error
- Displayed instead of user’s image, if difference or average is selected, but there is only one active device
- Displayed if the dimensions of the results of the selected devices are different
3 No user screen In „Main menu”/”MultiCONT config.”/”User display” „None” is selected
4 No active device Displayed during measurement or instead of user’s image, when there is no avtive device
5 No HART device The unit’s device list is empty ( run „DEV detect”
6 Locked The hardware switch is on ( the program cannot be modified)
7 No current output Displayed in the position of the „current output assignment” image, if there is no current output in the system
8 No relay output Displayed in the position of the „Relay assignment” image, if there is no relay in the system
To Next Page
Loading...