NIVELCO MultiCONT - 5.9. THE BOOT PROCESS

prw2101a0600p_01  88 / 105
5.9. THE BOOT PROCESS
At every powering on, a test program runs testing the MultiCONT hardware. The whole process can be followed on the display in English. The procedure takes
about 40s.
MultiCONT
Version: 01.02.00
Software version Release date of software version
System START CODE FLASH ERROR
RESTARTING!
Restart in case of error
System START
Testing DATA…
FLASH1 NOT PRESENT
RESTARTING!
FLASH2 NOT PRESENT
RESTARTING!
In case of DATA FLASH or page CRC error
DATA FLASH ERROR
RESTARTING!
Number of the wrong page
IA2 FLASH ERROR
IA1 FLASH ERROR
VARIABLE ERROR
RESTARTING!
VERSION UPDATE
DEFAULT LOADING
DEVICE ERROR
RESTARTING!
ROUTE ERROR
RESTARTING!
RELAY ERROR
RESTARTING!
CURRENT
ERROR","RESTARTING!
LOGER ERROR
TYPE ERROR RESTARTING!
U485 NOT PRESENT
RESTARTING!
M485 NOT PRESENT
RESTARTING!
Checking clock
in the background
In case of clock error relative time is shown on the display
Restarting
No error
Testing CODE
RTC NOT PRESENT
Page: 1234 Page: 1234 Page: 1234
In background:
In case of P_D type
devices LOGGER
unit is checked