Route Based VPN and BGP
Nokia IP40 Security Platform User’s Guide v1.1 127
Configuring ISP Dial-Up Profiles
Use the following command to configure ISP dial-up profiles by using the CLI wizard:
wizard dialup
For more information about how to use other dial-up commands, see th Nokia IP40 Security
Platform CLI Reference Guide, Version 1.1.
Use the following commands to modify ISP dial-up profiles:
set dialup profile <id>
user <username>
password <password>
number <telephone Number>
[authentication <none | pap | chap | any>
externalip <ip_address>
mtu <value>
staticdns <yes | no>
dns1 <ip_address>
dns2 <ip_address>
Use the following command to delete selected ISP dial-up profiles:
set dialup profile <id> disable
Route Based VPN and BGP
The Nokia IP40 Security Platform has built-in features to automatically detect the failure of an
IPSec VPN connection from a remote office or branch office to the headquarters. On failure, it
forwards the traffic by using an alternative link (dial backup or VPN) through another ISP.
The IP40 Security Platform uses Border Gateway Protocol (BGP) to detect IPSec VPN
connection failures, and to activate alternative links. IP40 monitors each IPSec VPN tunnel in
association with a BGP neighbor at the headquarters.
To Next Page
Loading...
