Nokia IP40 - Setting up Nokia IP40 Security Platform with an Apple Computer

Before You Install Nokia IP40 Security Platform
Nokia IP40 Security Platform User’s Guide v1.1 41
2. Click Obtain an IP address automatically.
Note
Nokia recommends that you use DHCP to assign IP addresses instead of assigning a
static IP address to your computer. To assign a static IP address, select Specify an IP
address and enter an IP address in the range of 192.168.10.129 to 254. Enter
255.255.255.0 as the subnet mask. Click Ok to save the new settings.
3. Click Obtain DNS server address automatically.
4. Click OK to save the new settings.
Your computer is now ready to access your IP40.
Setting Up Nokia IP40 Security Platform with an Apple Computer
Use the following procedure to set up the TCP/IP protocol:
To make TCP/IP settings
1. Choose Apple Menus > Control Panels > TCP/IP.
The TCP/IP Window appears.
2. Select Ethernet from the Connect via drop-down list.
3. Select Using DHCP Server from the Configure drop-down list.
4. Close the window and save the setup.