Nokia IP40 - For VPN Connection with Smartcenter FP3; Setting up Check Point Smartcenter NG AI by Using Certificates with Smart LSM; Setting up the Nokia IP40 Satellite X

Nokia IP40 Tele 8 to Check Point NG AI
Nokia IP40 Security Platform User’s Guide v1.1 193
Source: any
Destination: any
If Via: Remote access
Action: accept
Install On: FP3 firewall object
Setting Up the Nokia IP40 Satellite X
for VPN connection with SmartCenter FP3
The following sections describe about how to setup Nokia IP40 Satellite X for VPN
configuration with SmartCenter FP3:
To configure the IP40 Satellite X for VPN connection with SmartCenter FP3
1. Specify the IP address of Nokia IP40 Satellite X on the VPN-1 server.
2. Enter the shared secret (a password that is known to both the IP40 Satellite X and the VPN-
1 Server).
Setting Up Check Point SmartCenter NG AI by Using
Certificates with Smart LSM
Configure the Check Point SmartCenter NG AI for a VPN connection with Nokia IP40 Satellite
X using Certificates with Smart LSM.
To set up Check Point Smart LSM
1. Define a VPN-1 Edge/Embedded ROBO gateway with a dynamic IP address on the Smart
LSM.
2. Create a Check Point Smart LSM object on the Check Point Smart Dashboard.
3. Create a new Star Community.
4. Configure a VPN central gateway as the NG AI firewall object.
5. Configure VPN-1 Edge/Embedded gateway as a Satellite X gateway.
6. Define access rules with the following parameters:
Source: Any
Destination: Any
If Via: Star Community
Action: Accept
Install On: NG AI firewall object