14 Working with VPNs
186 Nokia IP40 Security Platform User’s Guide v1.1
Setting Up Nokia IP40 Tele 8
Configure a VPN tunnel between an IP40 Tele 8 and an IP40 Satellite X.
Setting Up Nokia IP40 Satellite X
Configure a VPN tunnel between an Nokia IP40 Tele 8 and an Nokia IP40 Satellite X.
To set up Nokia IP40 Satellite X
1. Add a User.
2. Enable VPN remote access for the user you added.
3. Enable the VPN Server.
Nokia IP40 Tele 8 to Check Point
FP1,FP2, FP3, NG, or NG AI
You can use the IP40 Tele 8 as a VPN client to establish a Remote to Site VPN connectivity with
a Check Point server by using version 4.1, FP1, FP2, FP3, NG, or NG AI.
For more information, see Check Point documentation
Setting Up Nokia IP40 Tele 8
Configure a VPN tunnel between an IP40 Tele 8 and an IP40 Satellite X.
Setting Up Check Point Server
Open the Check Point policy editor and select the Firewall-1/ VPN -1 workstation object that
will receive the VPN-1 Edge/Embedded gateway session request.
For more information, see Check Point FP3 documentation
Nokia IP40 Tele 8 to Check Point NG AI
The Nokia IP40 Tele 8 can be used as a VPN client to establish a VPN connectivity with Check
Point NG AI server using VPN-1 Edge/Embedded gateway dynamic object. This topology uses
a remote access VPN community.
IP40 Tele 8 uses a manual mode VPN connection only.To select the VPN gateway to establish a
VPN connection, go to http://my.vpn.
To Next Page
Loading...
