Configuring Remote Access VPNs
Nokia IP40 Security Platform User’s Guide v1.1 165
If you choose Specify Configuration, a second VPN Network Configuration dialog box
appears. Do the following:
a. In the Destination network column, enter up to three destination network addresses at the
VPN site to which you want to connect.
b. In the Subnet mask column, select the subnet masks for the destination network
addresses.
Note
Obtain the destination networks and subnet masks addresses from the VPN gateway’s
system administrator.
c. In the configure backup gateway column, type the name of the VPN gateway to use if the
primary VPN gateway fails.
Note
The backup gateway can be configured only in case of Check Point Multiple Entry Point.
For information about how to configure the primary and secondary Check Point
management stations, see the Check Point Multiple Entry Point document.
d. Click Next.
The VPN Login page appears.
4. Do one of the following:
a. To configure the site for manual login, select Manual Login. Enter a username and
password to be used for logging on to the VPN site.
b. To enable the IP40 to log on to the VPN site automatically, Select Automatic Login
To Next Page
Loading...
