Service
7-15
Part 1120130
E 2011 Nordson Corporation
Filter Cartridge
To replace the filter cartridge
1. Ensure the melter is at operating temperature.
2. Relieve system pressure. Refer to Section 1, Safety.
M10
SW 24
3. Apply high temperature grease to all threads and O‐rings.
4. Insert the filter cartridge and tighten it to approximately 15 NSm
(133in.‐lb).
5. Feed material by allowing the pump to run until the material comes out of
the hose connection or applicator free of bubbles.
6. Properly dispose of material according to local regulations.
To Next Page
Loading...
