Location of the optional motion
switch
Service
7-4
Part 1120130
E 2011 Nordson Corporation
Locking Out the Motor Drives
To perform some troubleshooting and repair activities, the main power to the
melter needs to be on and/or the melter needs to be at application
temperature. To prevent injury, the optional motion switch can be used to
lock out the motor drives while leaving the main power on.
To lock out the motor drives but leave the main power on, place the motion
switch in the OFF position. The main power to the melter will remain on and
the melter will stay at application temperature.
External Cleaning
CAUTION! Do not damage or remove safety labels. Damaged or removed
safety labels must be replaced by new ones.
S Remove material residue only with a cleaning agent recommended by
the material supplier. Heat with an air heater if necessary.
S Remove dust, flakes, etc. with a vacuum cleaner or a soft cloth.
S Nordson recommends the orange cleaning agent, P/N 771192 (12 spray
bottles, 0.5 l each).
To Next Page
Loading...
