Nordson AltaBlue - Adjusting Pump RPM in Gear-to-Line Mode; Using the Master Controls

Operating the Melter
5-6
Part 1120130
E 2011 Nordson Corporation
Adjusting Pump RPM in GeartoLine Mode
1. Access the Operator Display.
2. Touch the pump that is configured for Geartoline operation.
3. Touch Pump Speed (RPM).
S Enter the Desired Pump Speed (RPM) you want to use.
4. Touch Done.
Using the Master Controls
1. Navigate to the Operator Display.
2. You can do one of the following:
S All heaters
S All pumps
S Standby mode