Introduction
2-2
Part 1120130
E 2011 Nordson Corporation
Examples of Unintended Use
The melter may not be used under the following conditions:
S In defective condition
S Without insulation blanket and protective panels
S With electrical cabinet door open
S With tank lid open
S In a potentially explosive atmosphere
S When the values stated under Technical Data are not complied with.
The melter may not be used to process the following materials:
S Polyurethane hot melt adhesive (PUR)
S Explosive and flammable materials
S Erosive and corrosive materials
S Food products.
Residual Risks
In the design of the unit, every measure was taken to protect personnel from
potential danger. However, some residual risks can not be avoided:
S Risk of burns from hot material.
S Risk of burns when filling the tank, from the tank lid, and from the tank lid
supports.
S Risk of burns when conducting maintenance and repair work for which
the melter must be heated up.
S Risk of burns when attaching and removing heated hoses.
S Material fumes can be hazardous. Avoid inhalation.
S Risk of damage to cables/lines belonging to the customer, if they were
installed such that they come into contact with hot or rotating parts.
S The safety valve may malfunction due to hardened or charred material.
To Next Page
Loading...
