Nordson AltaBlue - Configuring and Modifying Temperature, Pump and Melter Settings

Configuring and Modifying Temperature, Pump and Melter Settings
6-1
Part 1120130
E 2011 Nordson Corporation
Section 6
Configuring and Modifying Temperature,
Pump and Melter Settings
WARNING! Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Overview
The melter is shipped from the factory with most temperature, pump and
melter (system) settings preconfigured and ready to use. However, there are
some settings that you must configure and finetune to best fit your
manufacturing process.