Nordson AltaBlue - Line-Speed Signal Generator; Optional Fittings

Parts
9-84
Part 1120130
E 2011 Nordson Corporation
Line‐Speed Signal Generator
To use the gear‐to‐line capability of the melter, you must install a device that
measures the speed of the production line. The default type of line‐speed
signal input is 0-10 VDC, although other inputs can be accepted. Nordson
Corporation offers the following 0-10 VDC generator.
Part Description Note
119560 Generator, 0-10 VDC, with bracket and cable
Optional Fittings
See Figure 9‐49. These fittings can be used at the melter end of a hose.
Hose Size
Fitting
PartNumber
Fitting Type
Fitting Size,
Melter Side
Fitting Size,
HoseSide
8‐mm
7400333 Straight M16 x 1.5
9
/
16
‐18 JIC
7400337 45‐degree M16 x 1.5
9
/
16
‐18 JIC
7400335 90‐degree M16 x 1.5
9
/
16
‐18 JIC
12‐mm
7401279 Straight M16 x 1.5
3
/
4
‐16 JIC
7401278 45‐degree M16 x 1.5
3
/
4
‐16 JIC
7401277 90‐degree M16 x 1.5
3
/
4
‐16 JIC
16‐mm (see Note)
7400334 Straight M22 x 1.5 1
1
/
16
JIC
7400338 45‐degree M22 x 1.5 1
1
/
16
JIC
7400336 90‐degree M22 x 1.5 1
1
/
16
JIC
1
2
3
Figure 9-49 Typical non‐swivel fittings
1. Straight fitting 2. 45_ fitting 3. 90_ fitting