Repair
6-12
Part 1612500−02
E 2018 Nordson Corporation
Switch Installation (contd)
Figure 6-12 Installing the Trigger Switch − Step 4
7. See Figure 6-13. Install the purge trigger (43) into the spray trigger (41)
with the gusset oriented upward as shown. Do not install the purge
trigger upside down.
8. Verify that the actuator (42) is installed over the post.
9. Position the triggers in the handle and hold them in place while pressing
the axle (41A) through the handle and triggers until the head of the axle
is flushed with the handle. The axle will snap into place when properly
installed.
41A
41
43
41
42
43
Gusset
Figure 6-13 Reinstalling the Trigger and Axle
10. Reconnect the trigger switch connector to the round cable connector,
then tuck the connectors back up to the handle.
11. Reinstall the ground cover as described in Cable Installation steps 5−7
on page 6-9.
To Next Page
Loading...
