Chapter 6 - Creating Waypoints
951/952 Operator’s Manual Rev. B Page 93
NO WAYPTS OR ROUTES TO TRANSFER and the sta-
tus-bar message NO TRANSFER DONE.
•
If the master unit is completely full of waypoints and
routes (no more room available), the master unit displays
the dialog-box message LOCAL UNIT STATUS ERROR
[002] DATABASE FULL and the status-bar message COM-
MUNICATION ERROR.
7. If there isn’t any problem with the transfer process, when
done, the master unit’s status bar displays the message
TRANSFER COMPLETE. You can now press any key to
resume other operations.
Moving waypoints
and routes from a
unit
When you move waypoints from unit 1 (the designated mas-
ter) into unit 2, the entire contents of unit 1 are exported into
unit 2. Also, if any waypoint or route name matches exist, the
waypoints or routes from unit 1 will overwrite the waypoints or
routes already in unit 2.
NOTE:
If you press any function key on the master unit during the transfer, the
error message
TRANSFER ABORTED BY KEY HIT
will be displayed,
the process will be aborted, and the master unit will display the particular
screen accessed by that function keypress. You can press any key on the
other unit without interrupting the transfer process.
To purposely stop the transfer at any time, press the
key. If you
press the
key, the master unit displays the dialog-box message
TRANSFER ABORTED BY KEY HIT
, and the status bar displays the
message
TRANSFER ABORTED
. Waypoints and routes transferred up
to that point are in the receiving unit (be aware that a particular route may
not comprise all of its waypoints due to the transfer interruption). Press
the
key again to re-start the entire transfer process (this means
that all waypoints and routes, not just the ones already in the receiving
unit and the ones left to be transferred, are re-transferred).
1. Select the unit you’d like to use as the “master.” Remem-
ber: You can use either of two units because both units
are capable of importing or exporting waypoints and
routes.
To Next Page
