nuwavenow.com
23
ENGLISH
nuwavenow.com
23
3. Adjust Stage 2 cooking temperature and time by using
the [↑] and [↓] buttons.
4. To set additional stage cooking settings, repeat steps
2 and 3. The number above stage will change as you
continue to press the STAGE button and set temperature
and time. After Stage 5, if the STAGE button is pressed
again it will go back to Stage 1. The LED display will
show Stage 1 set cooking temperature, temp, stage, and
1 (above stage).
5. If you only want two (2) stages of cooking, leave the time
at 00:00 for stages 3~5 and those stages will be skipped.
6. Press the START/PAUSE button to begin cooking. The
unit will cook with the set parameters.
7. During cooking, press the STAGE button to see and
adjust upcoming cooking stages.
8. When the unit is nished cooking the LED display will
show End and beep three (3) times.
9. The STAGE button is also used to scroll through the
cooking function that have been set for a particular
recipe. Press the STAGE button, either before or during
cooking, to see and edit each function of the cooking
cycle as desired. This is explained later in this Manual.
Note:
• The LED display will only indicate the stage cooking
number when two (2) or more stages are used. The LED
display will not show stage number if only one (1) stage
of cooking is used.
• Stage 1 default: 360F, 00:15
• Stage 2~5 default: 360F, 00:00
• If no time is set for stages 2~5, those stages will be
skipped in the cooking cycle.
To Next Page
Loading...
