Table 61. Revision history (continued)
Revision Date Description of changes
• Moved table for 176 LQFP before 252 MAPBGA and updated table.
• Replaced table for 252 MAPBGA with two separate tables for package with full solder balls
and package with 16 removed balls.
In section Ordering information, replaced the table.
3 09/2015 On the cover page:
• Changed doctype from "Data Sheet: Product Preview" to "Data Sheet: Technical Data" at the
upper left corner.
• Changed statement on status of doc at the bottom of the page.
Removed "Preliminary" and "Non-Disclosure Agreement required" from footers on each page.
In section Electromagnetic Compatibility (EMC) removed content of entire section and replaced it
with statement: "EMC measurements to IC-level IEC standards are available from Freescale on
request."
In section Operating conditions :
• In Table 3
• For VDD_HV_PMC, removed the two footnotes.
• For VDDSTBY, added statement on ramp rate to footnote.
• For VSTBY_BO, removed Min value and added Max value.
In section DC electrical specifications :
• In Table 5 :
• IDD_LV spec:
• MPC5746R/MPC5745R Max value changed to 700 mA.
• MPC5743R/MPC5742R Max value changed to 610 mA.
• IDDSTBY_ON TA=40°C and TA=85°C values updated.
• IVDDA values updated.
In section I/O pad specification, Table 6 Description for Input only pads, removed reference to
"Automotive" input.
In section Input pad specifications, Table 7 removed VIHAUTO, VILAUTO, VHYSAUTO, and
VDRFTAUTO specs and references to "Automotive" input in footnotes.
In section Output pad specifications :
• In Table 9, removed footnote for tR_F spec Parameter about transition time maximum value
approximation formula.
In section Reset pad (PORST, RESET) electrical characteristics :
• In Table 12 :
• Changed specs for VIH, VIL, and VHYS to VIH Reset, VIL Reset, and VHYS Reset
respectively.
• Added specs for VIH PORST, VIL PORST, VHYS PORST.
• Generally added Conditions and updated spec values. In the Conditions column,
changed all instances of "3.0 V" to "3.5 V".
In section Oscillator and FMPLL :
• In Table 13, for ΔPLL0LTJ spec, modified long term jitter Min and Max values.
• In Table 16, values updated.
• In Table 17, added spec for dfTRIM (IRC software trimming step).
In section ADC input description :
• In Table 18 :
• RPUPD 5KΩ spec Max value changed to 8.8KΩ.
In section Input equivalent circuit and ADC conversion characteristics :
Table continues on the next page...
Revision history
SPC5746R Microcontroller Data Sheet, Rev. 6, 06/2017
NXP Semiconductors 95
To Next Page
Loading...
