NXP Semiconductors MPC5746R - Page 97

Table 61. Revision history (continued)
Revision Date Description of changes
• Modified the descriptions in the two paragraphs after the tables.
• Removed the third paragraph after the tables and the first Note.
Added section DSPI CMOS slave mode.
In section Ordering information table "Ordering Information", changed Part Numbers for the 176
LQFP PD and the ED.
5 10/2016 Editorial updates.
In section Operating conditions table "Device operating conditions" added foootnote to
V
DD_HV_IO_JTAG
.
In section Input pad specifications table "I/O input DC electrical characteristics" for I
LKG
added
condition "V
SS
< V
IN
< V
DD_HV_IO*
"
In section ADC input description table "Analog Input Leakage and Pull-Up/Down DC electrical
characteristics" for ILK_AD added conditions "V
SS_HV_ADV_SAR
< V
IN
< V
DD_HV_ADV_SAR
" and
"V
SS_HV_ADV_SD
< V
IN
< V
DD_HV_ADV_SD
".
In section Recommended power transistors table "Recommended operating characteristics" for
I
CMaxDC
changed the parameter from "Minimum peak collector current" to "Maximum DC collector
current".
In section SAR ADC table "ADC conversion characteristics":
• Removed the condition for t
sample
.
• Removed the Min and added the formula (6.02*ENOB) + 1.76 for SINAD.
• Changed the Min value from 650 to 700 for t
conv
.
In section S/D ADC table "SDn ADC electrical specification":
• Removed Z
IN
specification
• Added Z
DIFF
, Z
CM
, and ΔV
INTCM
specifications
• For R
BIAS
:
• Changed Parameter description from "Bias resistance" to "Bare bias resistance"
• Changed Min from 100 kΩ to 110 kΩ
• Changed Typ from 125 kΩ to 144 kΩ
• Changed Max from 160 kΩ to 180 kΩ
In section Flash memory AC timing specifications table "Flash memory AC timing specifications" for
t
psus
:
• Changed Typical from 7 μs plus four system clock periods to 9.4 μs plus four system clock
periods
• Changed Max from 9.1 μs plus four system clock periods to 11.5 μs plus four system clock
periods
6
05/2017 Changed Freescale to NXP throughout the datasheet.
In Ordering information added rows for SPC5746RK1MLU3, SPC5745RK1MMT5 and
SPC5743RK1MLU5.
In Table 3 added footnote in V
DD_HV_PMC
In Table 28 for the rowset C
HV_FLA
changed the Minimum and Typical values.
Revision history
SPC5746R Microcontroller Data Sheet, Rev. 6, 06/2017
NXP Semiconductors 97