- 307 -
9. Operating Management/ Specifications
Only when Point Calculation Type is a default setting, the setting is available on the Web page of the machine. If [Cost
Settings] is not displayed, check the Point Calculation Type setting.
Set numbers of points for paper size and Color/Mono (Grayscale). For example, you can set
so that bigger size paper needs more points or color printing needs more points than
grayscale printing. Points are charged on a page-by-page basis, so when you print two
pages, you need twice as much as the set rate.
In addition, you can apply point reduction system for two-sided printing or saving toner to
print. The reduction rate for saving toner also depends on [Toner Saving Calculation Setting].
1
Open the Web page of the machine.
Open the Web Page of This Machine
2
Log in as the administrator.
Log In as the Administrator
3
Click [Account Management].
4
Click [Cost Settings].
5
Set paper size points, toner points.
The default value for each paper size point is calculated based on the area ratio of the paper to A4 paper.
Setting Paper Size Points/Toner Points
To Next Page
Loading...
Need help?
General
