- 57 -
3. Scan
You can search for a destination from a list on the LDAP server. There are two search
methods, as shown below.
• [Simple Search]: You can run a search with only one keyword as a user
name. You can only search for character strings included in usernames, and
not in e-mail addresses.
• [Advanced Search]: You select search conditions to search for items that
include all the specified keywords or any of the keywords. You can specify
user names or e-mail addresses as search keywords.
Up to 100 search results are displayed.
For details on setting the LDAP server, refer to "Setting the LDAP Server".
1
Press the (SCAN) button on the operator panel.
2
Set a document in the ADF or on the document glass.
3
Check that [E-mail] is selected, and then press the button.
4
Press the or button to select [LDAP] and press the button.
5
Press the or button to select [Simple Search] or [Advanced Search],
and press the button.
6
Enter a keyword to search.
7
Select [Enter], and then press the (OK) button.
8
When the search results are displayed, press the or button to select
destinations, and then press the (OK) button.
You can select multiple items.
9
Press the or button to select all destinations needed, and then press
the (OK) button.
10
Check that [Complete] is selected, and then press the (OK) button.
11
Press the button to go back to the standby screen.
12
Set scan settings if necessary.
13
Press the (OK) button.
14
Press the (MONO) or (COLOR) button.
Specifying a Destination Searching LDAP Server
To Next Page
Loading...
Need help?
General
