Coax Emulation
171
SCS Buffer Cntrl
This option is used in Coax LU1/SCS mode only.
• Don’t Wait (default). The printer does not wait for the job to be
printed before sending the print completion to the host.
• Wait Until Done. The printer waits for the job to print before
sending the print completion to the host.
This option speeds up the LU1 job printing for short jobs. If you
select “Don’t Wait,” there is a risk that you may not be able to
recover the print job when the printer has fault.
Cancel IGP/DCU
• Enable (default). Cancels all buffers when a job is put on hold
from the host or when the CANCEL key is pressed.
• Disable. Does not cancel any internal buffer in the printer when
a job is put on hold from the host or when the CANCEL key is
pressed.
PTX Transparent
Lead-in Chars
You can enable additional printer features which are not accessible
through standard Coax emulations. To access these features, send
text commands in the data stream. The commands must have a
start and end code. Four sets are available:
• Set 1. start code: <%
stop code: >
• Set 2. start code:¬¬
stop code: $
• Set 3. start code: _%
stop code: _
• User Defined.
To Next Page
Loading...
Need help?
General