Chapter 4 Coax/Twinax (CTHI) Emulation
192
Auto Skip At End
Specifies whether or not to perform an automatic form feed at the
end of a print buffer. If form feed is the last character in the print
order, the form feed function is supplied by the Auto Skip At End
option.
• Off (default). Sets the printer to print at print position 1 of the
next line.
• On. Sets the printer to print at print position 1 of the first line of
the next form.
FF After Job
Determines the print position after an operator-initiated local copy
(print screen function).
• Off (default). Performs an automatic new line command after
completing a print buffer (unless a new line, form feed, or
carriage return command was the last one executed). The
printer is set to print at print position 1 of the next line.
• On. Performs an automatic form feed command unless a form
feed was the last one executed. The printer is set to print at
print position 1 of the first line on the next form.
CR, EM, and NL (3287 only)
CR (Carriage Return), EM (Error Message), and NL (New Line)
specify that the printer treat the CR, EM, and NL control codes
either as spaces or as control codes.
• On (default). Treats the CR, EM, and NL commands as control
codes.
• Off. Treats the CR, EM, and NL commands as spaces.
To Next Page
Loading...
Need help?
General