5250 Params
197
Usr Defined HTRN
This option is used to set user defined lead-in characters. The
range is ASCII character. This option allows users to define ther
own lead-in characters for the OKI Specific commands. Select a
hex value for the following codes for the User Defined option:
• Start Code 1 5F (default)
• Start Code 2 5F
• Stop Code 5B
Alt. Set 80-9F
• Printable (default). Prints data in the range of hex 80 through
hex 9F.
• Control Code. Interprets data in the range of hex 80 through
hex 9F as a control code.
Graphic Chek Err
Allows overriding of the host setting for the SGEA (Set Graphic
Error Action) command. For more information about the SGEA
command, refer to the
Coax/Twinax Programmer's Reference
Manual
.
• Enable (default). The host setting for the SGEA used by the
printer. If the SGEA command is requested to stop on graphic
errors, the printer will stop when a graphic error is detected.
• Disable. Ignores the SGEA command from the host. The
printer does not stop when an error is detected; instead, it
substitutes the character selected in the Graphic Chek Code
parameter.
To Next Page
Loading...
Need help?
General