Olivetti PR4 SR - 3.3 Slip Test Procedure; 3.4 Roll Test Procedure

3-4Service ManualXYAA6336
3.3 SLIP TEST
Activating this procedure makes it possible to check
the efficiency of the slip alignment assembly.
Operator action:
Activate the slip test mode as described in Secton 4.
Printer action:
1. Mechanical reset
2. Waits for slip insertion
Operator action:
Insert the slips successively and check alignment.
3.4 ROLL TEST
Activating this procedure makes it possible to check
the efficiency of the roll assembly.
Operator action:
Activate the roll test mode as described in Section 4.
Printer action:
PR4: Continuous printing on receipt and journal.
PR4 SR: Continuous printing on receipt
Note: This cycle lasts approximately two hours for
the receipt, four hours for the journal.
These cycles are used at the factory during the run-
in phase.
To interrupt the cycle open the front cover.