The Ultimate Ice Resurfacer 55
There are two ways of properly tightening the blade bolts:
Blade Bolt Sequence “A”
Sequence A – starting at one end of the blade, tighten the bolts consecutively across the blade
to the opposite end.
Remove the blade hooks and insert the remaining two blade bolts and tighten.
Blade Bolt Sequence “B”
Sequence B – starting in the middle tighten the bolts from the centre to one end then return to
the centre and tighten the bolts to the other end in order. Remove the blade hooks and insert
the remaining two blade bolts and tighten.
To Next Page
Loading...
