Olympus DP2-SAL - 2 Outputting measurement results in CSV file; 3 Displaying cross lines

DP2-SAL
69
Select button.
Click the mouse on 2 arbitrary points to create the reference line (line
passing 1 and 2 shown in the left picture).
Right-click the mouse on the position you want to measure. The
perpendicular is drawn.
When drawing multiple perpendiculars on the reference line,
left-click
the mouse to draw the perpendicular. Note, at the last
position, right-click
the mouse to draw the perpendicular.
You can measure another position continuously. Right-click the mouse
on the window to finish.
1
2
3
4
Perpendicular
By creating the line and then specifying one point, the perpendicular line is drawn from the specified point to the
created line, and the length of the perpendicular line drawn is measured.
A line (reference line)
passing through 1 and 2
is drawn.
The perpendicular passing
3 and also orthogonal to
the reference line and its
length are displayed.
Select button.
Click the mouse on 2 arbitrary points to create the reference line (line
passing 1 and 2 shown in the left picture).
Right-click the mouse on the position you want to measure. A parallel
line is drawn.
When drawing multiple parallel lines for the reference line,
left-click
the mouse to draw the parallel lines. Note, at the last
position, right-click
the mouse to draw the parallel line.
You can measure another position continuously. Right-click the mouse
on the window to finish.
1
2
3
4
Parallel line distance
A pair of the parallel lines is created on the image and its distance is measured.
A parallel line passing through 3 is drawn
and the distance between parallel lines is
displayed. The length of the parallel line
drawn is same as the distance of the line
passing through 1 and 2.
A line passing through 1 and 2
is drawn.