Omron CJ2H-CPU6*-EIP Series User Manual

8-83
8 Pulse Outputs
CJ2M CPU Unit Pulse I/O Module User’s Manual
8-10 Precautions when Using Pulse Outputs
8
8-9-4 Feeding Wrapping Material: Interrupt Feeding
z Differences between Set Frequencies and Actual Frequencies
The following tables show when a second pulse control instruction can be started if a pulse control
operation is already being executed.
A second independent-mode positioning instruction can be started if an independent-mode positioning
instruction is being executed, and a second continuous-mode speed control instruction can be started if
a continuous-mode speed control instruction is being executed.
Operation cannot be switched between the independent and continuous modes. But a PLS2(887)
instruction can be executed while a ACC(888) instruction (continuous mode) is being executed.
It is possible to start another operation during acceleration/deceleration and start another positioning
instruction during positioning.
Source clock frequency: 33,330 MHz
Set frequency (kHz) Actual frequency (kHz)
99.941 to 100.000 100.090
99.642 to 99.940 99.790
::
50.008 to 50.082 50.045
49.933 to 50.007 49.970
::
10.002 to 10.004 10.003
9.999 to 10.001 10.000
9.996 to 9.998 9.997
Combinations of Pulse Control Instructions
Yes: Can be executed. No: Error occurs.
Instruction being executed
Instruction being started
INI
SPED
(Inde-
pendent)
SPED
(Contin-
uous)
ACC
(Inde-
pen-
dent)
ACC
(Con-
tinu-
ous)
PLS2 ORG IFEED
SPED (Independent) Yes Yes
(*1)
No Yes
(*3)
No No No No
SPED (Continuous) Yes No Yes
(*2)
No Yes
(*5)
No No No
ACC (Inde-
pendent)
Steady speed Yes No No Yes
(*4)
No Yes
(*6)
No No
Accelerating or
decelerating
Ye s N o N o Ye s
(*4)
No Yes
(*6)
No No
ACC: con-
tinuous
Steady speed Yes No No No Yes
(*5)
Ye s
(*7)
No No
Accelerating or
decelerating
Ye s N o N o N o Ye s
(*5)
Ye s
(*7)
No No
PLS2 Steady speed Yes No No Yes
(*4)
No Yes
(*8)
No No
Accelerating or
decelerating
Ye s N o N o Ye s
(*4)
No Yes
(*8)
No No
ORG Steady speed Yes No No No No No No No
Accelerating or
decelerating
YesNoNo NoNoNoNoNo
IFEED(892)
instruction
Steady speed Yes No No No No No No Yes
(*9)
Accelerating or
decelerating
YesNoNo NoNoNoNoYes
(*9)

Omron CJ2H-CPU6*-EIP Series Specifications

General

Brand	Omron
Model	CJ2H-CPU6*-EIP Series
Category	Controller
Language	English