6-13 Uploading and Verifying Device Parameters
6-13-4 Verifying Device Parameters
6-13-4 Verifying Device Parameters
The following two methods can be used to compare the parameters of network
devices for verification with corresponding parameters in the CX-Integrator.
1) Comparing the parameters of devices selected from the Network Configuration
Window
2) Comparing the parameters through the Edit Device Parameters Dialog Box
Using the Network Configuration Window
Component - Parameter - Compare
To compare the parameters through the Network Configuration Window, use the
following procedure.
1. Place the CX-Integrator online.
2. Select the device.
3. Select Component - Parameter - Compare.
The following confirmation dialog box will be displayed.
4. Click the Yes Button.
The progress dialog box will be displayed and the parameters will be compared for
verification.
If there are any comparison errors, the following dialog box with the details of the
errors will be displayed.
6-60
To Next Page
Loading...
Need help?
General