8-1 NT Link Connection Auto-detect Function
8-1-2 Procedure
6. The following warning dialog box will be displayed.
If you click the OK Button, the CPU Unit’s RS-232C port’s communications settings
will be overwritten. Verify that the CPU Unit’s RS-232C port is not communicating
and then click the OK Button.
7. The following dialog box will be displayed when an NS-series PT is connected to
the CPU Unit’s RS-232C port.
Verify that the pin 5 of the CPU Unit’s DIP switch is OFF and then click the OK
Button.
8. The NT Link Connection Auto-detect Function will be executed.
The following dialog box will be displayed to show the progress of the automatic
connection operation.
9. The following dialog box will be displayed if the connection with the PT is
established automatically.
Click the OK Button.
8-4
To Next Page
Loading...
Need help?
General