EasyManuals Logo

Omron F3SJ-A series User Manual

Omron F3SJ-A series
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
vii
F3SJ-A
User’s Manual
Introduction
Introduction
E
Double or reinforced insulation from hazardous voltage must be applied to all input and output lines. Failure to
do so may result in electric shock.
Extension of the cable must be within a specified length. If it isn't, safety function may not work properly,
resulting in danger.
Other
To use the F3SJ in PSDI mode (Reinitiation of cyclic operation by the protective equipment), you must
configure an appropriate circuit between the F3SJ and the machine. For details about PSDI, refer to
OSHA1910.217, IEC61496-1, and other relevant standards and regulations.
Do not try to disassemble, repair, or modify this product. Doing so may cause the safety functions to stop
working properly.
Do not use the F3SJ in environments where flammable or explosive gases are present. Doing so may result in
explosion.
Perform daily and 6-month inspections for the F3SJ. Otherwise, the system may fail to work properly, resulting
in serious injury.
Courtesy of CMA/Flodyne/Hydradyne Motion Control Hydraulic Pneumatic Electrical Mechanical (800) 426-5480 www.cmafh.com

Table of Contents

Other manuals for Omron F3SJ-A series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron F3SJ-A series and is the answer not in the manual?

Omron F3SJ-A series Specifications

General IconGeneral
BrandOmron
ModelF3SJ-A series
CategoryAccessories
LanguageEnglish

Related product manuals