Omron LD-90 - Page 21

Chapter 1: Introduction
(Windows 7)Start >Control Panel >(Network and Internet >)Network and Sharing Center
>Change adapter settings
(Windows 10)Start >Settings >Network and Internet >Change adapter options
Right-click on the LAN Connection, and click on Properties.
In the Properties dialog, scroll to and double-click the Internet Protocol (TCP/IP or TCP/IPv4)
option. In Internet Protocol Properties, click both “Use the following…” radio buttons to enable
them, and then type in the IP and Subnet mask values. See the following figure:
Figure 1-8. Internet Protocol Properties Pop-up Dialog
SetNetGo Access
If MobilePlanner is available, use MobilePlanner’s SetNetGo interface to access SetNetGo.
Otherwise, open a web browser, enter the URL: https://1.2.3.4, then confirm security certificates.
Regardless of how you accessed SetNetGo, you should now have a window similar to the fol-
lowing:
11970-000 Rev M LD-60/90 Platform User's Manual 21