Oracle Database Appliance X6-2-HA

Preparing to Service
Caution - Hazardous voltage present. Never run the system with the top cover removed.
Caution - Equipment damage. Install the system top cover properly before starting the system.
For your protection, observe the following safety precautions when setting up your equipment:
■
Follow all cautions, warnings, and instructions marked on the equipment and described
in Important Safety Information for Oracle's Hardware Systems and Oracle Database
Appliance Safety and Compliance Guide.
■
Ensure that the voltage and frequency of your power source match the voltage and
frequency inscribed on the equipment's electrical rating label.
■
Follow the electrostatic discharge safety practices as described in this chapter.
Required Tools
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
Oracle Database Appliance can be serviced with the following tools:
■
Antistatic wrist strap
■
Antistatic mat
■
No. 2 10-inch Phillips screwdriver (magnetic tip recommended)
■
Flat blade screwdriver
■
Stylus or pencil (to press the Clear CMOS button)
Obtaining the Chassis Serial Number
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
142 Oracle Database Appliance Service Manual • November 2017