Oracle Database Appliance X6-2-HA Service Manual

Install Front Indicator Panel
See the Oracle Database Appliance Owner's Guide for instructions.
b.
Reconnect the power cords to the system and power on the system.
See “Powering On Oracle Database Appliance Version 1” on page 249.
Servicing Server Node Cables
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section includes information on servicing cables in Oracle Database Appliance Version 1.
The internal server node cables are FRUs and can only be replaced by an Oracle-qualified
service technician.
Caution - Equipment damage. These procedures require that you handle components that are
sensitive to static discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow antistatic practices as described in “Performing Electrostatic Discharge
and Antistatic Prevention Measures” on page 146.
The following topics are covered in this section:
■
“Servicing the Fan Power Cables (FRU)” on page 227
■
“Servicing the PCIe Card Cables (FRU)” on page 230
■
“Servicing the SAS Expander Cable (FRU)” on page 235
■
“Servicing the Boot Disk Backplane Cables (FRU)” on page 237
Servicing the Fan Power Cables (FRU)
Each Oracle Database Appliance Version 1 server node has two fans and each fan has a separate
power cable.
Appendix A • Servicing the Oracle Database Appliance Version 1 227

Oracle Database Appliance X6-2-HA Specifications

General

Brand	Oracle
Model	Database Appliance X6-2-HA
Category	Storage
Language	English