Remove a Server Node From the System Chassis
When handling components such as storage drive assemblies, circuit boards, or PCIe cards:
■
Attach an antistatic strap to your wrist and then to a metal area on the chassis. Following
this practice equalizes the electrical potential between you and the system.
Note - An antistatic wrist strap is not included in the system Accessory Kit. However,
antistatic wrist straps are included with some options and components.
■
Place ESD-sensitive components on an antistatic mat. The following items can be used as
an antistatic mat:
■
Antistatic bag used to wrap a replacement part
■
ESD mat
■
Disposable ESD mat (shipped with some replacement parts or optional system
components)
Removing Server Nodes From the System Chassis
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
You must remove the Oracle Database Appliance Version 1 server node from the chassis to
remove or replace internal server node components.
Remove a Server Node From the System Chassis
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
The removal procedure is the same for both server nodes. Note that you do not need to remove
the entire system chassis from the rack to perform service procedures on a server node.
Appendix A • Servicing the Oracle Database Appliance Version 1 147
To Next Page
Loading...
Need help?
General