Oracle Database Appliance X6-2 Series Server Node Hot-Pluggable Components
The system will then detect and use the new storage.
For additional information, refer to the Oracle Database Appliance Deployment and User's
Guide.
Oracle Database Appliance X6-2 Series Server Node Hot-
Pluggable Components
This section describes replacing hot-pluggable components for the Oracle Database Appliance
X6-2 series server node.
If you have Oracle Database Appliance X7-2 series, go to “Oracle Database Appliance
X7-2 Series Server Node Hot-Pluggable Components” on page 65. If you have the
Oracle Database Appliance X3-2/X4-2/X5-2, go to “Oracle Database Appliance X3-2/
X4-2/X5-2 Server Node Hot-Pluggable Components” on page 77. If you have Oracle
Database Appliance Version 1, go to “Oracle Database Appliance Version 1 Hot-Pluggable
Components” on page 98.
Hot-pluggable components are those that can be removed and installed while the system is
running. These are designated as Customer Replaceable Units (CRUs).
Note - After a physical insertion or removal action of a storage component (such as a disk or
SAS cable), you should wait before performing the next action to allow the system software to
fully process the event. This could take up to 3 minutes to complete.
Refer to the following table for hot-plug component instructions for your appliance.
Note - Some of the links in the following table take you to instructions outside of the Oracle
Database Appliance library to the Oracle Server X6-2 and Oracle Server X6-2L (including
Storage Server X6-2 Extreme Flash version) documentation libraries. Use your browser's Back
button to return to the Oracle Database Appliance library.
Oracle Database Appliance X6-2S/
X6-2M
Oracle Database Appliance X6-2L Oracle Database Appliance X6-2-HA
Servicing Non-NVMe Storage
Drives (CRU)
Servicing Non-NVMe Rear Storage
Drives (CRU)
Servicing Non-NVMe Storage
Drives (CRU)
“Servicing NVMe Storage Drives
(CRU)” on page 72
“Servicing NVMe Storage Drives
(CRU)” on page 72
NVMe storage drives are not
supported in the server nodes for this
product.
Chapter 3 • Servicing CRUs That Do Not Require System Power Off 71