Preparing Oracle Database Appliance X6-2 Series for Service
Note - The links in the following table take you to instructions outside of the Oracle Database
Appliance library to the Oracle Server X7-2 documentation library. Use your browser's Back
button to return to the Oracle Database Appliance library.
Oracle Database Appliance X7-2S/X7-2M Oracle Database Appliance X7-2-HA
Safety Precautions Safety Precautions
Safety Symbols Safety Symbols
Electrostatic Discharge Safety Electrostatic Discharge Safety
Required Tools Required Tools
Powering Down the Server Powering Down the Server
Disconnect Cables From the Server Disconnect Cables From the Server
Extend the Server to the Maintenance Position Extend the Server to the Maintenance Position
Remove the Server From the Rack Remove the Server From the Rack
Take Antistatic Measures Take Antistatic Measures
Remove the Server Top Cover Remove the Server Top Cover
Preparing Oracle Database Appliance X6-2 Series for
Service
This section describes preparing Oracle Database Appliance X6-2 series for service.
If you have Oracle Database X7-2 series, go to “Preparing Oracle Database Appliance
X7-2 Series for Service” on page 61. If you have Oracle Database X3-2, Oracle
Database Appliance X4-2, or Oracle Database Appliance X5-2, go to “Preparing Oracle
Database Appliance X3-2/X4-2/X5-2 for Service” on page 63. If you have Oracle
Database Appliance Version 1, go to “Preparing Oracle Database Appliance Version 1 for
Service” on page 64.
Most service procedures are performed on a single appliance component. Service procedures
that require a single server node to be powered off can be performed without shutting down
the entire appliance. Before powering off any component for service, refer to the Deployment
and User's Guide for the Oracle Database Appliance X6 series for any special instructions or
commands that must be performed on the appliance to prepare it for service.
62 Oracle Database Appliance Service Manual • November 2017
To Next Page
Need help?
General